Author Description

Elastic stiffness tailoring of laminated composite panels by allowing the fibers to curve within the plane of the laminate is a relatively novel design concept that has been demonstrated to be both beneficial and practical. In particular, for structures with highly non-uniform stress states, such as the case of a flat panel with a central hole subjected to in-plane loading, the concept is likely to provide substantial improvements in load carrying capability. The objective of the present study is to determine the effectiveness of stiffness tailoring through the use of curvilinear fibers to reduce stress concentrations around the hole and improve the load carrying capability of panels with holes. In this study software was created that translates standard finite element models with traditional laminate definitions into ones that possess stacking sequences with curvilinear fiber paths that are directly manufacturable using an advanced tow placement machine. Preliminary designs for the manufacturing and testing phase were determined through rudimentary design studies for flat plates without holes under axial compression. These candidate designs were then analyzed using finite element models that accurately reflect the test conditions and geometries in order to select final designs for testing. A total of six large panels, measuring three feet by six feet, each of which are used to produce four specimens with or without holes, were fabricated and delivered to NASA for machining and testing.Tatting, Brain F. and Guerdal, Zafer and Jegley, Dawn (Technical Monitor)Langley Research CenterFLAT PLATES; LAMINATES; MANUFACTURING; PANELS; STIFFNESS; FIBER ORIENTATION; ELASTIC PROPERTIES; COMPRESSION LOADS; GRAPHITE-EPOXY COMPOSITES; FIBER COMPOSITES; FABRICATION; FINITE ELEMENT METHOD; HOLES (MECHANICS); LOAD DISTRIBUTION (FORCES); MACHINING; NONUNIFORMITY; STRESS CONCENTRATION; STACKING SEQUENCE (COMPOSITE MATERIALS)...